-
- Chevrolet Camaro: LS/LT to SS Front Bumper Conversion (For 2010-2013 models)
- Infiniti Q50: Q50 to Q50s Sport Front Bumper Conversion (For 2014-2017 models)
- Lexus CT200H: CT200H to F-Sport Front Bumper Conversion (For 2011-2017 Models)
- Scion FRS to Toyota 86 Front Bumper Conversion (For 2013-2016)
- Toyota Tacoma: 3rd Generation TRD Hood Conversion (For 2016-2020 models)
- Toyota 4Runner: Hood and Scoop Conversion (for 2010-2022 Models)
- Toyota Tundra: Chrome Delete Conversion Kit (For 2022 Model)
- Toyota Tacoma: Rear End Caps Chrome to Painted Conversion (For 2016-2023 Models)
- Request Conversion Parts
- Customer Reviews
- Request Car Part
- PAINT MATCH GUARANTEE
- FAQ
- HELP
- ORDER STATUS
- 281-561-5300
- Login
How to Replace 2008 to 2013 Nissan Rogue Rear Bumper
Here is how to replace your 2008 to 2015 Nissan Rogue rear bumper cover. This tutorial covers removal and installation. The process is not as difficult as you may think.
To replace your 2008 to 2015 Nissan Rogue rear bumper cover, you'll need:
New Nissan Rogue rear bumper cover
Flat-head screwdriver
Socket wrench set
Follow these steps to replace your Nissan Rogue rear bumper:
1. Start with the wheel wells. Using a 10mm socket wrench, remove the bolt that is found between the bumper and the frame of the vehicle.
2. At the bottom of the bumper near the tire, remove another bolt. Do steps 1 and 2 on the other side of the vehicle.
3. Remove the plastic push pins found under the bumper. There are 5 spread across from end to end.
4. Open the tailgate and remove the bolts securing the bumper found on both sides.
5. Safely remove the bumper starting from one end. The bumper should fall off easily.
6. Snap your new bumper on.
7. Replace the bolts (removed in step 4) to secure the bumper.
8. Make sure that both ends of the bumper are snapped properly.
9. Put back the bolts found in between the bumper and the frame of the vehicle (removed in step 1).
10. Put back the bolts at the bottom of the bumper on each side (removed in step 2).
11. Put back the push pins under the bumper. There should be 5 (removed in step 3).
12. Check and tighten the bolts.
There you have it: the steps to replace your Nissan Rogue rear bumper.
DISCLAIMER: While ReveMoto tries to make the information in this blog as accurate as possible, we make no claims, promises, or guarantees about the accuracy, completeness, or applicability of the content. No information contained in this blog shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself (DIY) projects entail some risk. It is the sole responsibility of the viewer to assume this risk. ReveMoto is not responsible or liable for any loss, damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this blog.